User's Manual

Chapter 5 Easy Mode
EMG2926-Q10A User’s Guide
33
Figure 20 Easy Mode: Status Screen
5.2 What You Can Do
You can do the following in this mode:
•Use the Na viga t ion Panel to opt out of the Easy M ode (
Section 5.4 on page 34).
•Use the N et w ork M ap screen to check whether your EMG2926-Q10A is connected to the
Internet or any networking devices and view the transmission speed between them when
StreamBoost is enabled. At the time of writing, the StreamBoost feature is turned off on the
EMG2926-Q10A.
•Use the Cont rol Pa n e l to configure and enable EMG2926-Q10A features, including wireless
scheduling, wireless security,
parental control, firewall and so on (Section 5.6 on page 35).
•Use the Stat u s Screen to view read-only information about the EMG2926-Q10A, including the
WAN IP, MAC address of the EMG2926-Q10A, the firmware version and wireless settigns (Section
5.7 on page 41
).
5.3 What You Need to Know
Between the different device modes, the Con t rol Panel (
Section 5.6 on page 35) changes
depending on which features are applicable to the mode:
• Router Mode: All Cont rol Panel features are available.
Control Panel
Status Screen
Go to
Network
Map
Screen
Navigation Panel