User's Manual
Table Of Contents
- EMG2926-Q10A
- User’s Guide
- Technical Reference
- Monitor
- WAN
- Wireless LAN
- LAN
- DHCP Server
- NAT
- DDNS
- Static Route
- Firewall
- Content Filtering
- Parental Control
- IPv6 Firewall
- StreamBoost Management
- Remote Management
- Universal Plug-and-Play (UPnP)
- USB Media Sharing
- Port Configuration
- Maintenance
- Troubleshooting
- Legal Information
- Index
Chapter 8 Tutorials
EMG2926-Q10A User’s Guide
60
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see Section 3.2 on page 28).
1 Make sure the W I FI switch (at the side panel of the EMG2926-Q10A) is set to ON.
2 Open the Con figura t ion > N e tw ork > W ir ele ss LAN 2 .4 G > Gener a l screen in the AP’s Web
Configurator.
3 Confirm that the wireless LAN is enabled on the EMG2926-Q10A.
4 Enter SSI D _ Ex a m ple 3 as the SSID and select Channel- 0 6 as the channel. Set security mode to
W PA2 - PSK and enter Thisism yW PA- PSKpre- sharedkey in the Pre - Share d Ke y field. Click
Apply.