User's Manual

Chapter 9 Monitor
EMG2926-Q10A User’s Guide
73
Figure 46 Monitor > Packet Statistics
The following table describes the labels in this screen.
9.6 WLAN Station Status
Click M onit or > W LAN 2 .4 G/ 5 G St a t ion St at us or the W LAN 2 .4 G/ 5 G St at ion Sta t us
( De t ails...) hyperlink in the St a t us screen. View the wireless stations that are currently associated
to the EMG2926-Q10A’s 2.4GHz or 5GHz wireless network in the Association List. Association
means that a wireless client (for example, your network or computer with a wireless network card)
Table 25 Monitor > Packet Statistics
LABEL DESCRIPTION
Port This is the EMG2926-Q10A’s interface type.
Status For the LAN ports, this displays the port speed and duplex setting or Dow n when the
line is disconnected.
For the WAN port, it displays the port speed and duplex setting if you’re using Ethernet
encapsulation and I dle (line (ppp) idle), D ial (starting to trigger a call) and Dr op
(dropping a call) if you're using PPPoE encapsulation. This field displays Dow n when
the line is disconnected.
For the 2.4GHz or 5GHz WLAN, it displays the maximum transmission rate when the
WLAN is enabled and D ow n when the WLAN is disabled.
TxPkts This is the number of transmitted packets on this port.
RxPkts This is the number of received packets on this port.
Collisions This is the number of collisions on this port.
Errors This is the number of received errors on this port.
Tx B/s This displays the transmission speed in bytes per second on this port.
Rx B/s This displays the reception speed in bytes per second on this port.
Up Time This is the total time the EMG2926-Q10A has been for each session.
System Up Time This is the total time the EMG2926-Q10A has been on.
Poll Interval(s) Enter the time interval in seconds for refreshing statistics in this field.
Set Interval Click this button to apply the new poll interval you entered in the Poll I nt erva l( s)
field.
Stop Click Stop to stop refreshing statistics.