User`s guide

G-3000H User’s Guide
180 Chapter 17 LAN Setup
Figure 109 Menu 3.2 TCP/IP Setup
Follow the instructions in the following table on how to configure the fields in this menu.
17.3 Wireless LAN Setup
Use menu 3.5 to set up your ZyAIR as the wireless access point. To edit menu 3.5, enter 3
from the main menu to display Menu 3 – LAN Setup. When menu 3 appears, press 5 and then
press [ENTER] to display Menu 3.5 – Wireless LAN Setup as shown next.
Menu 3.2 - TCP/IP Setup
IP Address Assignment= Static
IP Address= 192.168.1.2
IP Subnet Mask= 255.255.255.0
Gateway IP Address= 0.0.0.0
Table 63 Menu 3.2 TCP/IP Setup
FIELD DESCRIPTION
IP Address
Assignment
Press [SPACE BAR] and then [ENTER] to select Dynamic to have the ZyAIR
obtain an IP address from a DHCP server. You must know the IP address assigned
to the ZyAIR (by the DHCP server) to access the ZyAIR again.
Select Static to give the ZyAIR a fixed, unique IP address. Enter a subnet mask
appropriate to your network and the gateway IP address if applicable.
IP Address Enter the (LAN) IP address of your ZyAIR in dotted decimal notation
IP Subnet Mask Your ZyAIR will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the ZyAIR.
Gateway IP
Address
Type the IP address of the gateway. The gateway is an immediate neighbor of your
ZyAIR that will forward the packet to the destination. On the LAN, the gateway must
be a router on the same network segment as your ZyAIR.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [
ESC] at any time to cancel.