ZyAIR G-220F 802.11g Wireless USB Adapter Quick Installation Guide Version 1.
Important Note Federal Communications Commission (FCC) Interference Statement The 802.11g Wireless LAN USB Adapter has been tested to the FCC exposure requirements (Specific Absorption Rate). The equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment, under 47 CFR 2.1093 paragraph (d) (2). This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Refer to the User’s Guide for general FCC statements.
• A minimum of 6 MB available hard disk space • A minimum of 32 MB RAM • A CD-ROM drive • A USB port (version 2.0 compatible) • Windows 98 SE/Me/2000/XP • Windows 98 SE users may need the Windows 98 SE CD 2. ZyAIR Hardware and Utility Installation Follow the steps for your Windows version to install the ZyAIR G-220F. Windows XP 1. Locate an available USB port on the computer. 2. Remove the protective cap to expose the USB connector. Insert the ZyAIR G-220F to the USB port on the computer.
7. A Found New Hardware Wizard windows displays. Select Install the software automatically (recommended) and click Next. 8. Click Finish to complete the installation process. Windows 2000 1. Locate an available USB port on the computer. 2. Remove the protective cap to expose the USB connector. Insert the ZyAIR G-220F to the USB port on the computer. The LED turns on if the ZyAIR G-220F is properly inserted. Never bend, force or twist the ZyAIR G-220F into the port. 3.
2. Remove the protective cap to expose the USB connector. Insert the ZyAIR G-220F to the USB port on the computer. The LED turns on if the ZyAIR G-220F is properly inserted. Never bend, force or twist the ZyAIR G-220F into the port. 3. Windows automatically detects the ZyAIR and starts the installation process. Wait until a Preparing for ZyXEL ZyXIR G-220F driver and utility install … window displays. 4. A Welcome screen displays. Click Next. 5.
8. Remove the protective cap to expose the USB connector. Insert the ZyAIR G-220F to the USB port on the computer. The LED turns on if the ZyAIR G-220F is properly inserted. Never bend, force or twist the ZyAIR G-220F into the port. After you install the ZyAIR Utility and insert the ZyAIR G-220F, an icon appears in the system tray. If the ZyAIR Utility icon displays, the ZyAIR G-220F is installed properly. Refer to the ZyAIR Utility User’s Guide to configure the ZyAIR G-220F.
LED Display LED The following table describes the LED on the front panel of the ZyAIR G-220F. COLOR Blue STATUS DESCRIPTION On The ZyAIR G-220F has a connection to a wireless LAN. Blink (fast) The ZyAIR G-220F is sending or receiving data. Blink (slow) The ZyAIR G-220F is ready but not connected to a wireless LAN.
Troubleshooting PROBLEM Windows does not auto-detect the ZyAIR G-220F. CORRECTIVE ACTION Make sure the ZyAIR G-220F USB connecter is inserted into the computer USB port properly and then restart your computer. Check the LED on the ZyAIR G-220F. Perform a hardware scan by clicking Start, Settings, Control Panel and double-clicking Add/Remove Hardware. (Steps may vary depending on the version of Windows). Follow the on-screen instructions to search for the ZyAIR G220F and install the driver.
