User's Manual
Table Of Contents
- User’s Guide
- Copyright
- Federal Communications Commission (FCC) Interference Statement
- ZyXEL Limited Warranty
- Customer Support
- Table of Contents
- List of Figures
- List of Tables
- Preface
- 1. Getting Started
- 2. Wireless LAN Network
- 3. Wireless Station Mode Configuration
- 4. Access Point Mode Configuration
- 5. Maintenance
- 6. Troubleshooting
- A. Product Specifications
- B. Access Point Mode Setup Example
- C. Disable Windows XP Wireless LAN Configuration Tool
- D. Management with Wireless Zero Configuration
- E. Types of EAP Authentication
- F. Setting up Your Computer’s IP Address
- Index
ZyXEL G-220 v2 User’s Guide
Appendix B Access Point Mode Setup Example 67
APPENDIX B
Access Point Mode Setup Example
This example uses the network sharing feature in Windows 2000 to bridge the wired and
wireless network when you set the ZyXEL G-220 v2 in access point (AP) mode.
Refer to Chapter 4, “Access Point Mode Configuration,” on page 53 for setup methods and
requirements.
Steps may vary depending on your Windows version. You may need to install additional
software in Windows 98 Second Edition and Windows ME.
Configuring the Computer on Which You Install the ZyXEL G-
220 v2
1 Refer to Section 1.7.1 “Change ZyXEL G-220 v2 Mode” on page 25 to set the ZyXEL G-
220 v2 to operate in AP mode.
2 Click Start, Settings, Network and Dial-up Connections (or click Start, Settings,
Control Panel and double-click Network and Dial-up Connections).
Figure 35 Windows 2000: Start
3 Right-click on the icon for your wired Ethernet adapter and click Properties.