User's Manual
Table Of Contents
- User’s Guide
- Copyright
- Federal Communications Commission (FCC) Interference Statement
- ZyXEL Limited Warranty
- Customer Support
- Table of Contents
- List of Figures
- List of Tables
- Preface
- 1. Getting Started
- 2. Wireless LAN Network
- 3. Wireless Station Mode Configuration
- 4. Access Point Mode Configuration
- 5. Maintenance
- 6. Troubleshooting
- A. Product Specifications
- B. Access Point Mode Setup Example
- C. Disable Windows XP Wireless LAN Configuration Tool
- D. Management with Wireless Zero Configuration
- E. Types of EAP Authentication
- F. Setting up Your Computer’s IP Address
- Index
ZyXEL G-220 v2 User’s Guide
Appendix D Management with Wireless Zero Configuration 85
The following table describes the labels in this screen.
Smart Card or other Certificate Properties
Figure 60 Windows XP: Smart Card or other Certificate Properties
Table 29 Windows XP: Protected EAP Properties
LABEL DESCRIPTION
Validate server
certificate
Select the check box to verify the certificate of the authentication server.
Connect to these
servers
Select the check box and specify a domain in the field below to have your
computer connect to a server which resides only within this domain.
Trusted Root
Certification
Authorities:
Select a trusted certification authority from the list below.
Note: You must first have a wired connection to a network and
obtain the certificate(s) from a certificate authority (CA).
Consult your network administrator for more information.
Do not prompt
user to authorize
new server or
trusted
certification
authorities.
Select this check box to verify a new authentication server or trusted CA without
prompting.
This field is available only if you installed the Windows XP server pack 2.
Select
Authentication
Method:
Select an authentication method from the drop-down list box and click Configure
to do settings.
Enable Fast
Reconnect
Select the check box to automatically reconnect to the network (without re-
authentication) if the wireless connection goes down.
OK Click OK to save your changes.
Cancel Click Cancel to leave this screen without saving any changes you may have made.