User Manual

ZyXEL G-260 User’s Guide
45 Chapter 3 ZyXEL Utility Configuration
2 If you select the Infrastructure network type in the previous screen, skip to step 3. If you
select the Ad-Hoc network type in the previous screen, a screen displays as follows.
Select a channel number and wireless LAN mode and click Next to continue.
Figure 20 Profile: Wireless Setting: Select a Channel
The following table describes the labels in this screen.
3 If you select Infrastructure network type in the first screen, select WEP, WPA-PSK,
WPA2-PSK, WPA or WPA2 from the drop-down list box to enable data encryption. If
you select Ad-Hoc network type in the first screen, you can only use WEP encryption
method. Otherwise, select Disable to allow the ZyXEL G-260 to communicate with the
access points or other peer wireless computers without any data encryption and skip to
step 5.
Table 13 Profile: Wireless Setting: Select a Channel
LABEL DESCRIPTION
Wireless Setting
Channel Select a channel number from the drop-down list box. To associate to an ad-hoc
network, you must use the same channel as the peer computer.
Back Click Back to return to the Add New Profile screen.
Next Click Next to confirm your selection and advance to the Encryption Type screen.
Exit Click Exit to discard changes and return to the Add New Profile screen.