User guide
Table Of Contents
- Part1
- Part2
- Part2
- Part3
- Part4
- Part5
- Dynamic Link Aggregation
- Link Aggregation ID
- RADIUS
- Configuring RADIUS Server Settings
- Configuring IEEE802.1x
- Supported MIBs
- SNMP Traps
- Configuring SNMP
- Setting Up Login Accounts
- Requirements for Using SSH
- HTTPS Example
- Internet Explorer Warning Messages
- Netscape Navigator Warning Messages
- Login Screen
- Strict Priority Queuing (SPQ)
- Weighted Round Robin Scheduling (WRR)
- DiffServ
- DSCP and Per-Hop Behavior
- DHCP “Relay Agent Information Option”
- DHCP Relay Agent Circuit ID Sub-option Format
- Part6
- Part7
- Switch Configuration File
- Access Priority
- The Console Port
- Telnet
- List of Available Commands
- Detailed Command Information
- Logging Out
- User Mode
- Enable Mode
- Configure Mode
- config-vlan Commands
- interface Commands
- show system-information
- show hardware-monitor
- show ip
- show logging
- show interface
- show mac address-table
- Backing up Configuration
- Restoring Configuration
- Using a Different Configuration File
- Resetting to the Factory Default
- no mirror-port
- no https timeout
- no trunk
- no port-access-authenticator
- no ssh
- interface
- bpdu-control
- broadcast-limit
- bandwidth-limit
- mirror
- gvrp
- ingress-check
- frame-type
- vlan-trunking
- spq
- wrr
- egress set
- qos priority
- name
- speed-duplex
- Static Entries (SVLAN Table)
- Dynamic Entries (DVLAN Table)
- GARP Status
- GARP Timer
- GVRP Timer
- Enable GVRP
- Disable GVRP
- Set Port VID
- Set Acceptable Frame Type
- Enable or Disable Port GVRP
- Modify Static VLAN
- Delete VLAN ID
Dimension GS-3012 Gigabit Ethernet Switch
Introduction to CLI 28-3
Figure 28-2 CLI: Login Screen
28.4 Command Syntax Conventions
The rules of the commands are listed next.
The command keywords are in courier new font.
The required fields in a command are enclosed in angle brackets <>, for instance,
ping <ip> means that
you must specify an IP number for this command.
The optional fields in a command are enclosed in square brackets [], for instance,
configure snmp-server [contact <system contact>] [location <system location>]
means that the
contact and location fields are optional.
“Command” refers to a command used in the command line interface (CI command).
The | symbol means “or”.
The entry <cr> in the command lines refers to carriage return. Press [ENTER] or carriage return after a
command to execute the command.
Use the up (y) or down (z) arrow key to scroll through the command history list.
The CLI does not accept partial or incomplete commands. You may enter a unique part of a command and
press [TAB] to have the switch automatically display the full command. For example, if you enter
“config” and press [TAB], the full command of “
configuration” automatically displays.
Each interface refers to a switch Ethernet port. Commands configured after the interface command
correspond to those ports.
Type multiple ports or port ranges separated by a comma. Ranges of port numbers are typed separated by a
dash.
28.5 Getting Help
The system includes a help facility to provide you with the following information about the commands:
List of available commands under a command group.
Detailed descriptions of the commands.
28.5.1 List of Available Commands
Enter “help” to display a list of available commands and the corresponding sub commands.
Enter “
?” to display a list of commands you can use.
Enter User Name : admin
Enter Password : XXXX