User guide
Table Of Contents
- Part1
- Part2
- Part2
- Part3
- Part4
- Part5
- Dynamic Link Aggregation
- Link Aggregation ID
- RADIUS
- Configuring RADIUS Server Settings
- Configuring IEEE802.1x
- Supported MIBs
- SNMP Traps
- Configuring SNMP
- Setting Up Login Accounts
- Requirements for Using SSH
- HTTPS Example
- Internet Explorer Warning Messages
- Netscape Navigator Warning Messages
- Login Screen
- Strict Priority Queuing (SPQ)
- Weighted Round Robin Scheduling (WRR)
- DiffServ
- DSCP and Per-Hop Behavior
- DHCP “Relay Agent Information Option”
- DHCP Relay Agent Circuit ID Sub-option Format
- Part6
- Part7
- Switch Configuration File
- Access Priority
- The Console Port
- Telnet
- List of Available Commands
- Detailed Command Information
- Logging Out
- User Mode
- Enable Mode
- Configure Mode
- config-vlan Commands
- interface Commands
- show system-information
- show hardware-monitor
- show ip
- show logging
- show interface
- show mac address-table
- Backing up Configuration
- Restoring Configuration
- Using a Different Configuration File
- Resetting to the Factory Default
- no mirror-port
- no https timeout
- no trunk
- no port-access-authenticator
- no ssh
- interface
- bpdu-control
- broadcast-limit
- bandwidth-limit
- mirror
- gvrp
- ingress-check
- frame-type
- vlan-trunking
- spq
- wrr
- egress set
- qos priority
- name
- speed-duplex
- Static Entries (SVLAN Table)
- Dynamic Entries (DVLAN Table)
- GARP Status
- GARP Timer
- GVRP Timer
- Enable GVRP
- Disable GVRP
- Set Port VID
- Set Acceptable Frame Type
- Enable or Disable Port GVRP
- Modify Static VLAN
- Delete VLAN ID
Dimension GS-3012 Gigabit Ethernet Switch
28-10 Introduction to CLI
Table 28-2 Command Summary: Enable Mode
COMMAND DESCRIPTION
tftp config <ip>
<remote-file>
Restores configuration with the specified
filename from the specified TFTP server.
flash <ip>
<remote-file>
Restores firmware via TFTP.
ping <ip|host-name>
[<in-band|out-of-
band|vlan <vlan-id>]
[size <0-1472>]
[-t]
Sends a Ping request to an Ethernet
device.
traceroute <ip|host-name>
[in-band|out-of-
band|vlan <vlan-id>]
[ttl <1-255>]
[wait <1-60>]
[queries <1-10>]
Determines the path a packet takes to a
device.
ssh <1|2> <[user@]dest-
ip>
Connects to an SSH server with the
specified SSH version.
28.9.3 Configure Mode
The following table lists the commands in Configuration (or Config) mode.
Table 28-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
help
Displays help information.
logout
Exits from the CLI.
history
Displays a list of previously
command(s) that you have
executed.
exit
Exits from the CLI.
mode zynos
Changes the CLI mode to the
ZyNOS format.
password
Change the password for Enable
mode.
no ip
Sets the management IP address
to the default value.
route <ip> <mask>
inactive
Enables a specified IP static route.
route <ip> <mask>
Removes a specified IP static
route.