User guide
Table Of Contents
- Part1
- Part2
- Part2
- Part3
- Part4
- Part5
- Dynamic Link Aggregation
- Link Aggregation ID
- RADIUS
- Configuring RADIUS Server Settings
- Configuring IEEE802.1x
- Supported MIBs
- SNMP Traps
- Configuring SNMP
- Setting Up Login Accounts
- Requirements for Using SSH
- HTTPS Example
- Internet Explorer Warning Messages
- Netscape Navigator Warning Messages
- Login Screen
- Strict Priority Queuing (SPQ)
- Weighted Round Robin Scheduling (WRR)
- DiffServ
- DSCP and Per-Hop Behavior
- DHCP “Relay Agent Information Option”
- DHCP Relay Agent Circuit ID Sub-option Format
- Part6
- Part7
- Switch Configuration File
- Access Priority
- The Console Port
- Telnet
- List of Available Commands
- Detailed Command Information
- Logging Out
- User Mode
- Enable Mode
- Configure Mode
- config-vlan Commands
- interface Commands
- show system-information
- show hardware-monitor
- show ip
- show logging
- show interface
- show mac address-table
- Backing up Configuration
- Restoring Configuration
- Using a Different Configuration File
- Resetting to the Factory Default
- no mirror-port
- no https timeout
- no trunk
- no port-access-authenticator
- no ssh
- interface
- bpdu-control
- broadcast-limit
- bandwidth-limit
- mirror
- gvrp
- ingress-check
- frame-type
- vlan-trunking
- spq
- wrr
- egress set
- qos priority
- name
- speed-duplex
- Static Entries (SVLAN Table)
- Dynamic Entries (DVLAN Table)
- GARP Status
- GARP Timer
- GVRP Timer
- Enable GVRP
- Disable GVRP
- Set Port VID
- Set Acceptable Frame Type
- Enable or Disable Port GVRP
- Modify Static VLAN
- Delete VLAN ID

Dimension GS-3012 Gigabit Ethernet Switch
Introduction to CLI 28-15
Table 28-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
classifier <name>
<[packet-format
<802.3untag|802.3ta
g|
EtherIIuntag|EtherI
Itag>] [priority
<0-7>]
[vlan <vlan-id>]
[ethernet-type
<ether-num|ip|ipx|
arp|rarp|
appletalk|decnet|
sna|netbios|dlc>]
[source-mac <src-
mac-addr>]
[source-port <port-
num>] [destination-
mac <dest-mac-
addr>]
[dscp <0-63> ]
[ip-protocol
<protocol-
num|tcp|udp|icmp|eg
p| ospf|rsvp|igmp|
igp|pim|ipsec>
[establish-only]]
[source-ip <src-ip-
addr> [mask-bits
<mask-bits>]]
[source-socket
<socket-num>]
[destination-ip
<dest-ip-addr>
[mask-bits <mask-
bits>]]
[destination-socket
<socket-num>]
[inactive]>
Configures a classifier. A classifier
groups traffic into data flows
according to specific criteria such
as the source address, destination
address, source port number,
destination port number or
incoming port number.