User guide
Table Of Contents
- Part1
- Part2
- Part2
- Part3
- Part4
- Part5
- Dynamic Link Aggregation
- Link Aggregation ID
- RADIUS
- Configuring RADIUS Server Settings
- Configuring IEEE802.1x
- Supported MIBs
- SNMP Traps
- Configuring SNMP
- Setting Up Login Accounts
- Requirements for Using SSH
- HTTPS Example
- Internet Explorer Warning Messages
- Netscape Navigator Warning Messages
- Login Screen
- Strict Priority Queuing (SPQ)
- Weighted Round Robin Scheduling (WRR)
- DiffServ
- DSCP and Per-Hop Behavior
- DHCP “Relay Agent Information Option”
- DHCP Relay Agent Circuit ID Sub-option Format
- Part6
- Part7
- Switch Configuration File
- Access Priority
- The Console Port
- Telnet
- List of Available Commands
- Detailed Command Information
- Logging Out
- User Mode
- Enable Mode
- Configure Mode
- config-vlan Commands
- interface Commands
- show system-information
- show hardware-monitor
- show ip
- show logging
- show interface
- show mac address-table
- Backing up Configuration
- Restoring Configuration
- Using a Different Configuration File
- Resetting to the Factory Default
- no mirror-port
- no https timeout
- no trunk
- no port-access-authenticator
- no ssh
- interface
- bpdu-control
- broadcast-limit
- bandwidth-limit
- mirror
- gvrp
- ingress-check
- frame-type
- vlan-trunking
- spq
- wrr
- egress set
- qos priority
- name
- speed-duplex
- Static Entries (SVLAN Table)
- Dynamic Entries (DVLAN Table)
- GARP Status
- GARP Timer
- GVRP Timer
- Enable GVRP
- Disable GVRP
- Set Port VID
- Set Acceptable Frame Type
- Enable or Disable Port GVRP
- Modify Static VLAN
- Delete VLAN ID
Dimension GS-3012 Gigabit Ethernet Switch
28-18 Introduction to CLI
Table 28-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
timesync <daytime|time|ntp>
Sets the time server protocol.
server <ip>
Sets the IP address of your time
server.
loginPrecedence <LocalOnly |
LocalRADIUS |
RADIUSOnly>
Select which database the switch
should use (first) to authenticate a
user.
igmp-snooping
Enables IGMP snooping.
bcp-
transparency
Enables Bridge Control Protocol
Transparency.
queue level <0-7>
priority <0-7>
Sets the priority level-to-physical
queue mapping.
storm-control
Enables broadcast storm control
on the switch.
bandwidth-
control
Enables bandwidth control.
mac-aging-time <10-3000>
Sets learned MAC aging time.
snmp-server [contact <system
contact>] [location
<system location>]
Sets the geographic location and
the name of the person in charge
of this switch.
get-community
<property>
Sets the get community.
set-community
<property>
Sets the set community.
trap-community
<property>
Sets the trap community.
trap-destination
<ip>
Sets the IP addresses of up to four
stations to send your SNMP traps
to.
logins username <name>
password <pwd>
Configures up to four read-only
login accounts.
service-control icmp
Allows ICMP access to the switch
such as pinging and tracerouting.
snmp
Allows SNMP management.
http <socket-
number> <timeout>
Allows HTTP access on the
specified service port and defines
the timeout period.
telnet <socket-
number>
Allows Telnet access on the
specified service port.
ftp <socket-number>
Allows FTP access on the
specified service port.