User guide
Table Of Contents
- Part1
- Part2
- Part2
- Part3
- Part4
- Part5
- Dynamic Link Aggregation
- Link Aggregation ID
- RADIUS
- Configuring RADIUS Server Settings
- Configuring IEEE802.1x
- Supported MIBs
- SNMP Traps
- Configuring SNMP
- Setting Up Login Accounts
- Requirements for Using SSH
- HTTPS Example
- Internet Explorer Warning Messages
- Netscape Navigator Warning Messages
- Login Screen
- Strict Priority Queuing (SPQ)
- Weighted Round Robin Scheduling (WRR)
- DiffServ
- DSCP and Per-Hop Behavior
- DHCP “Relay Agent Information Option”
- DHCP Relay Agent Circuit ID Sub-option Format
- Part6
- Part7
- Switch Configuration File
- Access Priority
- The Console Port
- Telnet
- List of Available Commands
- Detailed Command Information
- Logging Out
- User Mode
- Enable Mode
- Configure Mode
- config-vlan Commands
- interface Commands
- show system-information
- show hardware-monitor
- show ip
- show logging
- show interface
- show mac address-table
- Backing up Configuration
- Restoring Configuration
- Using a Different Configuration File
- Resetting to the Factory Default
- no mirror-port
- no https timeout
- no trunk
- no port-access-authenticator
- no ssh
- interface
- bpdu-control
- broadcast-limit
- bandwidth-limit
- mirror
- gvrp
- ingress-check
- frame-type
- vlan-trunking
- spq
- wrr
- egress set
- qos priority
- name
- speed-duplex
- Static Entries (SVLAN Table)
- Dynamic Entries (DVLAN Table)
- GARP Status
- GARP Timer
- GVRP Timer
- Enable GVRP
- Disable GVRP
- Set Port VID
- Set Acceptable Frame Type
- Enable or Disable Port GVRP
- Modify Static VLAN
- Delete VLAN ID

Dimension GS-3012 Gigabit Ethernet Switch
Introduction to CLI 28-23
Table 28-5 Command Summary: Interface
COMMAND DESCRIPTION
speed-duplex <auto|10-half|10-full|100-
half|100-full|1000-full>
Sets the duplex mode (half, full)
and speed (10/100/1000 Mbps)
of the connection on the
interface. Selecting auto (auto-
negotiation) makes one port able
to negotiate with a peer
automatically to obtain the
connection speed and duplex
mode that both ends support.
bpdu-control <peer|tunnel|discard|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
no ingress-check
Incoming traffic is not checked
for VLAN tags.
no gvrp
Disables GVRP on the switch.
no flow-control
Disables flow control on the
switch.
no vlan-trunking
Disables VLAN trunking on the
switch.
no mirror
Disables port mirroring on the
switch.
no bandwidth-limit
Disables bandwidth limit on the
switch.
no broadcast-limit
Disables broadcast storm control
limit on the switch.
no multicast-limit
Disables multicast limit on the
switch.
no dlf-limit
Disables destination lookup
failure (DLF) on the switch.
no inactive
Enables the specified interface
on the switch.
inactive *
Disables the specified interface
on the switch
help
Displays a description of the
interface commands.
exit
Exits from the interface
configuration command set.
test
Performs an interface loopback
test.