User guide
Table Of Contents
- Part1
- Part2
- Part2
- Part3
- Part4
- Part5
- Dynamic Link Aggregation
- Link Aggregation ID
- RADIUS
- Configuring RADIUS Server Settings
- Configuring IEEE802.1x
- Supported MIBs
- SNMP Traps
- Configuring SNMP
- Setting Up Login Accounts
- Requirements for Using SSH
- HTTPS Example
- Internet Explorer Warning Messages
- Netscape Navigator Warning Messages
- Login Screen
- Strict Priority Queuing (SPQ)
- Weighted Round Robin Scheduling (WRR)
- DiffServ
- DSCP and Per-Hop Behavior
- DHCP “Relay Agent Information Option”
- DHCP Relay Agent Circuit ID Sub-option Format
- Part6
- Part7
- Switch Configuration File
- Access Priority
- The Console Port
- Telnet
- List of Available Commands
- Detailed Command Information
- Logging Out
- User Mode
- Enable Mode
- Configure Mode
- config-vlan Commands
- interface Commands
- show system-information
- show hardware-monitor
- show ip
- show logging
- show interface
- show mac address-table
- Backing up Configuration
- Restoring Configuration
- Using a Different Configuration File
- Resetting to the Factory Default
- no mirror-port
- no https timeout
- no trunk
- no port-access-authenticator
- no ssh
- interface
- bpdu-control
- broadcast-limit
- bandwidth-limit
- mirror
- gvrp
- ingress-check
- frame-type
- vlan-trunking
- spq
- wrr
- egress set
- qos priority
- name
- speed-duplex
- Static Entries (SVLAN Table)
- Dynamic Entries (DVLAN Table)
- GARP Status
- GARP Timer
- GVRP Timer
- Enable GVRP
- Disable GVRP
- Set Port VID
- Set Acceptable Frame Type
- Enable or Disable Port GVRP
- Modify Static VLAN
- Delete VLAN ID

Dimension GS-3012 Gigabit Ethernet Switch
Command Examples 29-1
This chapter describes some commands in more detail.
29.1 Overview
These are commands that you may use frequently in maintaining your switch.
29.2 show Commands
These are the commonly used show commands.
29.2.1 show system-information
Syntax:
show system-information
This command shows the general system information (such as the firmware version and system up time).
An example is shown next.
Figure 29-1 show system-information Command Example
29.2.2 show hardware-monitor
Syntax:
show hardware-monitor [c|f]
This command displays the current hardware status (such as temperature and voltage levels).
Chapter 29
Command Examples
System Name : GS-3012
System Contact :
System Location :
Ethernet Address: 00:13:49:11:22:34
ZyNOS F/W Version: V3.60(HO.0)b1 | 01/21/2005
RomRasSize : 2891036
System up Time : 0:56:32 (52d1d ticks)
Bootbase Version: V3.00 | 01/14/2005
ZyNOS CODE : RAS Jan 21 2005 21:40:05
Product Model : GS-3012
GS-3012>