User guide
Table Of Contents
- Part1
- Part2
- Part2
- Part3
- Part4
- Part5
- Dynamic Link Aggregation
- Link Aggregation ID
- RADIUS
- Configuring RADIUS Server Settings
- Configuring IEEE802.1x
- Supported MIBs
- SNMP Traps
- Configuring SNMP
- Setting Up Login Accounts
- Requirements for Using SSH
- HTTPS Example
- Internet Explorer Warning Messages
- Netscape Navigator Warning Messages
- Login Screen
- Strict Priority Queuing (SPQ)
- Weighted Round Robin Scheduling (WRR)
- DiffServ
- DSCP and Per-Hop Behavior
- DHCP “Relay Agent Information Option”
- DHCP Relay Agent Circuit ID Sub-option Format
- Part6
- Part7
- Switch Configuration File
- Access Priority
- The Console Port
- Telnet
- List of Available Commands
- Detailed Command Information
- Logging Out
- User Mode
- Enable Mode
- Configure Mode
- config-vlan Commands
- interface Commands
- show system-information
- show hardware-monitor
- show ip
- show logging
- show interface
- show mac address-table
- Backing up Configuration
- Restoring Configuration
- Using a Different Configuration File
- Resetting to the Factory Default
- no mirror-port
- no https timeout
- no trunk
- no port-access-authenticator
- no ssh
- interface
- bpdu-control
- broadcast-limit
- bandwidth-limit
- mirror
- gvrp
- ingress-check
- frame-type
- vlan-trunking
- spq
- wrr
- egress set
- qos priority
- name
- speed-duplex
- Static Entries (SVLAN Table)
- Dynamic Entries (DVLAN Table)
- GARP Status
- GARP Timer
- GVRP Timer
- Enable GVRP
- Disable GVRP
- Set Port VID
- Set Acceptable Frame Type
- Enable or Disable Port GVRP
- Modify Static VLAN
- Delete VLAN ID

Dimension GS-3012 Gigabit Ethernet Switch
29-10 Command Examples
known-hosts
<host-ip>
[1024|ssh-
rsa|ssh-dsa]
Remove remote known hosts with a specified public key (1024-bit RSA1,
RSA or DSA).
An example is shown next.
Disable the secure shell RSA1 encryption key.
Remove the remote host with IP address 172.165.1.8 from the list of known hosts.
Remove the remote host with IP address 172.165.1.9 and with an SSH-RSA encryption key from the list of known
hosts.
Figure 29-19 no ssh Command Example
29.8 interface Commands
These are some commonly used commands that belong to the interface group of commands.
29.8.1 interface
Syntax:
interface
Each interface refers to an Ethernet port on the switch. Commands configured after the interface command
correspond to those ports. Type multiple ports or port ranges separated by a comma. Ranges of port numbers are
typed separated by a dash.
An example is shown next.
Enter the configuration command set.
Enable ports one, three, four and five for configuration.
Begin configuring for those ports.
Figure 29-20 interface Command Example
29.8.2 bpdu-control
Syntax:
bpdu-control <peer|tunnel|discard|network>
where
GS-3012# config
GS-3012(config)# interface 1,3-5
GS-3012(config-interface)#
GS-3012(config)# no ssh key rsa1
GS-3012(config)# no ssh known-hosts 172.165.1.8
GS-3012(config)# no ssh known-hosts 172.165.1.9 ssh-rsa