User`s guide

Dimension GS-3012 Gigabit Ethernet Switch
29-2 Command Examples
Figure 29-2 show hardware-monitor Command Example
29.2.3 show ip
Syntax:
show ip
This command displays the IP related information (such as IP address and subnet mask) on all switch interfaces.
Figure 29-3 show ip Command Example
29.2.4 show logging
This command is not available in User mode.
Syntax:
show logging
This command displays the system logs. The following figure shows an example.
GS-3012> show ip
Out-of-band Management IP Address = 192.168.0.1
VPS00, Device Type: Ethernet, Idle/Timeout: disable
Number of Interface : 1
enif0 : IP[192.168.0.1], Netmask[255.255.255.0], VID[0]
VPS01, Device Type: Switch, Idle/Timeout: disable, [MGMT VPS], [CNTL VPS]
Number of Interface : 2
cmif0 : IP[127.0.0.1], Netmask[255.0.0.0], VID[1]
swif0 : IP[192.168.1.1], Netmask[255.255.255.0], VID[1]
GS-3012>
GS-3012> show hardware-monitor c
Temperature Unit : (c)
Temperature Current MAX MIN Threshold Status
MAC 32.0 32.0 26.0 65.0 Normal
CPU 30.0 30.0 25.0 65.0 Normal
PHY 31.0 31.0 26.0 65.0 Normal
FAN Speed(RPM) Current MAX MIN Threshold Status
FAN1 5716 5810 5536 4500 Normal
FAN2 5810 5859 5536 4500 Normal
FAN3 5908 5958 5670 4500 Normal
Voltage(V) Current MAX MIN Threshold Status
2.5 2.608 2.608 2.608 +/-5% Normal
1.25 1.280 1.296 1.280 +/-10% Normal
3.3 3.392 3.392 3.392 +/-5% Normal
12 12.160 12.160 12.160 +/-10% Normal
5 5.053 5.053 5.053 +/-5% Normal
1.3 1.328 1.328 1.328 +/-5% Normal
1.25 1.296 1.296 1.280 +/-5% Normal
GS-3012>