User`s guide

Chapter 22 Multicast
GS3700/XGS3700 Series User’s Guide
200
22.4.5 MLD Snooping-proxy Filtering Profile
Use this screen to create an MLD filtering profile and set the range of the multicast address(es).
Click the Filtering Profile link in the Advanced Application > Multicast > IPv6 Multicast >
MLD Snooping-proxy > Filtering screen to display the screen as shown.
Figure 118 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering >
Filtering Profile
The following table describes the labels in this screen.
Table 92 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering >
Filtering Profile
LABEL DESCRIPTION
Profile Name Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Start Address Type the starting multicast IPv6 address for a range of multicast IPv6 addresses that you
want to belong to the MLD filtering profile.
End Address Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and
End Address fields.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to reset the fields to the factory defaults.
Profile Name This field displays the descriptive name of the profile.
Start Address This field displays the start of the multicast IPv6 address range.
End Address This field displays the end of the multicast IPv6 address range.