Manualshelf

User`s guide

ManualsBrandsZyXEL Communications ManualsNetworkingGS3700 Series
291292293294295296297298299300
Chapter 37 DHCP
GS3700/XGS3700 Series User’s Guide
300
37.3.1 DHCPv4 Server Status Detail
Click IP Application > DHCP > DHCPv4 in the navigation panel and then click an existing index
number of a DHCP server configuration to view the screen as shown. Use this screen to view details
regarding DHCP server settings configured on the Switch.
Figure 189 IP Application > DHCP > DHCPv4 > Server Status Detail
The following table describes the labels in this screen.
37.4 DHCPv4 Relay
Configure DHCP relay on the Switch if the DHCP clients and the DHCP server are not in the same
broadcast domain. During the initial IP address leasing, the Switch helps to relay network
Table 150 IP Application > DHCP > DHCPv4 > Server Status Detail
LABEL DESCRIPTION
Start IP Address This field displays the starting IP address of the IP address pool configured for this DHCP
server instance.
End IP Address This field displays the last IP address of the IP address pool configured for this DHCP
server instance.
Subnet Mask This field displays the subnet mask value sent to clients from this DHCP server instance.
Default Gateway This field displays the default gateway value sent to clients from this DHCP server
instance.
Primary DNS
Server
This field displays the primary DNS server value sent to clients from this DHCP server
instance.
Secondary DNS
Server
This field displays the secondary DNS server value sent to clients from this DHCP server
instance.
Address Leases This section displays information about the IP addresses this DHCP server issued to
clients.
Index This field displays a sequential number for each DHCP request handled by the Switch.
IP Address This is the IP address issued to a DHCP client.
Timer This field displays the time remaining before the DHCP client has to renew its IP address.
Hardware Address This field displays the MAC address of the DHCP client.
It may also display SELF OCCUPIED ADDRESS if the IP address cannot be used for
DHCP because it is already assigned to the Switch itself.
Hostname This field displays the system name of the client.