User`s guide

Chapter 38 VRRP
GS3700/XGS3700 Series User’s Guide
314
38.2 VRRP Status
Click IP Application > VRRP in the navigation panel to display the VRRP Status screen as shown
next.
Figure 201 IP Application > VRRP Status
The following table describes the labels in this screen.
38.3 VRRP Configuration
The following sections describe the different parts of the VRRP Configuration screen.
38.3.1 IP Interface Setup
Before configuring VRRP, first create an IP interface (or routing domain) in the IP Setup screen
(see the Section 6.5 on page 62 for more information).
Table 160 IP Application > VRRP Status
LABEL DESCRIPTION
Index This field displays the index number of a rule.
Network This field displays the IP address and the subnet mask bits of an IP routing domain that is
associated to a virtual router.
VRID This field displays the ID number of the virtual router.
VR Status This field displays the status of the virtual router.
This field is Master indicating that this Switch functions as the master router.
This field is Backup indicating that this Switch functions as a backup router.
This field displays Init when this Switch is initiating the VRRP protocol or when the Uplink
Status field displays Dead.
Uplink Status This field displays the status of the link between this Switch and the uplink gateway.
This field is Alive indicating that the link between this Switch and the uplink gateway is up.
Otherwise, this field is Dead.
This field displays Probe when this Switch is check for the link state.
Poll Interval(s) The text box displays how often (in seconds) this screen refreshes. You may change the
refresh interval by typing a new number in the text box and then clicking Set Interval.
Stop Click Stop to halt system statistic polling.