User`s guide

Chapter 39 Load Sharing
GS3700/XGS3700 Series User’s Guide
323
The following table describes the labels in this screen.
Table 164 IP Application > Load Sharing
LABEL DESCRIPTION
Active Select this option to enable Equal-Cost MultiPath (ECMP) routing on the Switch.
Criteria Select the criteria the Switch uses to determine the routing path for a packet.
Select src-ip to have the Switch use a hash algorithm to convert a packet’s source IP
address into a hash value which acts as an index to a route path.
Select src-dst-ip to have the Switch use a hash algorithm to convert a packet’s source and
destination IP addresses into a hash value which acts as an index to a route path.
Aging Time Specify the time interval (from 0 to 86400 in increments of 10) in seconds at which the
Switch sends an ARP request to update a resolved next-hop’s MAC address.
Discover Time Specify the time interval (from 0 to 86400 in increments of 10) in seconds at which the
Switch sends an ARP request to update an unresolved next-hop’s MAC address.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.