TV Converter Box User Manual

MC100FX-SC2/30-A User’s Guide
6
100Base-TX port
The 10/100BASE-TX port supports network speeds of either 10Mbps or 100Mbps, and can
operate in half- and full-duplex transfer modes. This port also offers automatic MDI/MDI-X
crossover detection that gives the device true "plug-n-play" capability – just plug the network
cable into the port and the port will adjust according to the end-node device automatically. The
RJ-45 connector is suitable for UTP cable of Category 3, 4, 5 or better.
100Base-FX port
The 100BASE-FX port has a fiber Fast Ethernet link to your network device. Compliant with
IEEE 802.3u, this port can transmits data at 100Mbps in full duplex mode across distances of up
to 2km over multi-mode fiber-optic cable, and 30km over single-mode fiber-optic cable. The fiber
port has SC fiber connectors.
LED Indicators
This Converter has LED indicators located at the front of the device.
The LEDs have been designed to give at-a-glance readings of different conditions and provides
‘real-time’ connectivity information. Below is an interpretation of their functions:
Port and Unit LEDs
LED Condition Status
On (Green) The port is operating at 100Mbps
100
Off The port is operating at 10Mbps
On (Green) Illuminated when connectors are attached
Flashing (Green) Data traffic passing through port
LNK/ACT
Off No valid link established on port
On (Amber) Port is operating at full-duplex
Flashing (Amber) Indicates collisions
FDX/COL
Off Port is operating at half-duplex
On (Green) converter is receiving power
PWR
Off Power off or failure
On (Red) Disruption of connection in copper or fiber segment
LFS
Off Copper / fiber segment is normal