User manual

PLA450 User’s Guide
115
CHAPTER 14
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• PLA-450 Access and Login
• Internet Access
• Resetting the PLA-450 to Its Factory Defaults
• Wireless Troubleshooting
• HomePlug AV Troubleshooting
• Advanced Features
14.1 Power, Hardware Connections, and LEDs
V The PLA450 does not turn on. None of the LEDs turn on.
1 Make sure you are using the power adaptor or cord included with the PLA450.
2 Make sure the power adaptor or cord is connected to the PLA450 and plugged in to an
appropriate power source. Make sure the power source is turned on.
3 Disconnect and re-connect the power adaptor or cord to the PLA450.
4 If the problem continues, contact the vendor.
V One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 1.4 on page 25.
2 Check the hardware connections. See the Quick Start Guide.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the PLA450.
5 If the problem continues, contact the vendor.