User manual

PLA450 User’s Guide
123
CHAPTER 15
Product Specifications and Wall-
Mounting Instructions
The following tables summarize the PLA450’s hardware and firmware features.
Table 36 Hardware Features
Dimensions (W x D x H) 116 x 118 x 35 mm
Power Specification 120-240 VAC, 50/60 Hz
Ethernet port Auto-negotiating:
This auto-negotiation feature allows the PLA450 to detect the speed of
incoming transmissions and adjust appropriately without manual
intervention. It allows data transfer of either 10 Mbps or 100 Mbps in either
half-duplex or full-duplex mode depending on your Ethernet network.
Auto-crossover:
Use either crossover or straight-through Ethernet cables.
Reset Button The reset button is built into the rear panel. Use this button to restore the
PLA450 to its factory default settings. Press for 1 second to restart the
device. Press for 5 seconds to restore to factory default settings.
Antenna The PLA450 is equipped with a 2dBi detachable antenna to provide clear
radio transmission and reception on the wireless network.
Operation Environment Temperature: 0º C ~ 45º C
Humidity: 5% ~ 95% RH (Noncondensing)
Storage Environment Temperature: -10º C ~ 70º C
Humidity: 10% ~ 85% RH (Noncondensing)
Distance between the
centers of the holes on
the device’s back.
115 mm
Screw size for wall-
mounting
use M3 screws made of plastic (not included)
Table 37 Firmware Features
FEATURE DESCRIPTION
Default IP Address 192.168.1.2
Default Subnet Mask 255.255.255.0 (24 bits)
Default Password 1234
DHCP Pool 192.168.1.33 to 192.168.1.64
Device Management Use the web configurator to easily configure the rich range of features on
the PLA450.