User manual

Chapter 6 Wireless LAN
PLA450 User’s Guide
73
Figure 38 Network > Wireless LAN > Advanced
The following table describes the labels in this screen.
Table 16 Network > Wireless LAN > Advanced
LABEL DESCRIPTION
Roaming Configuration
Enable
Roaming
Select this option if your network environment has multiple APs and you want your
wireless device to be able to access the network as you move between wireless
networks.
Wireless Advanced Setup
RTS/CTS
Threshold
Data with its frame size larger than this value will perform the RTS (Request To
Send)/CTS (Clear To Send) handshake.
If the RTS/CTS value is greater than the Fragmentation Threshold value, then the
RTS/CTS handshake will never occur as data frames will be fragmented before they
reach RTS/CTS size.
Enter a value between 256 and 2346.
See Appendix D on page 159 for more information.
Fragmentation
Threshold
It is the maximum data fragment size that can be sent. Enter a value between 256
and 2346.
See Appendix D on page 159 for more information.
Enable Intra-
BSS Traffic
A Basic Service Set (BSS) exists when all communications between wireless clients
or between a wireless client and a wired network client go through one access point
(AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is
enabled, wireless client A and B can access the wired network and communicate
with each other. When Intra-BSS is disabled, wireless client A and B can still access
the wired network but cannot communicate with each other.
See Appendix D on page 159 for more information.
Output Power Set the output power of the PLA450 in this field. If there is a high density of APs
within an area, decrease the output power of the PLA450 to reduce interference with
other APs.