User manual

Chapter 6 Wireless LAN
PLA450 User’s Guide
78
6.11 WPS Station Screen
Use this screen to set up a WPS connection using the Push Button Configuration (PBC)
method. You can use the push-button in the screen below or the external push-button on the
side of your device, if it has one. See Section 2.2 on page 35 for instructions on using WPS
using the external WPS button.
You can also use this screen to set up a WPS connection using the PIN of another WPS-
enabled device. See Section 6.5.1 on page 64 for instructions on using WPS with a PIN.
Click Network > Wireless LAN > WPS Station for the following screen to display.
Figure 42 Network > Wireless LAN > WPS Station
Generate Click this to have the PLA450 use a different WPS PIN. The new
PIN is automatically generated. The PLA450 uses the new PIN
once you click Apply.
To connect additional devices to your PLA450 using WPS you can
use the same PIN again or generate a new one for each setup
procedure.
WPS Status
Status This displays the current WPS configuration status. If no wireless
settings (such as security settings) are configured Unconfigured
displays. Once the WPS process is complete, Configured displays
in this field.
Apply Click this to save your changes to the PLA450.
Refresh Click this to reload the information in this screen.
Table 19 Network > Wireless LAN > WPS
LABEL DESCRIPTION