Switch - Hub User Manual

NSA-2400 Quick Start Guide

2 The NDU installation wizard begins. Follow the

installer instructions. Click Finish to complete the

installation.

3 In Windows XP, click start, All Programs, ZyXEL

NSA-2400, ZyXEL NSA-2400 Discovery Utility to run the NDU.

For other Windows operating systems, procedures should be

similar. If your computer has more than one network card, then

you will first be prompted to select a network interface card.

4 The NDU main screen appears listing all

hostnames, IP addresses and status of all NSAs

in your network. Click the icon under Admin to

see the main web configurator screen as shown

in Section 4 on page 6. (If you want to change the

NSA IP address, click the icon under Config. If

you want to map the NSA to a Windows network

drive, click the icon under Map (see Section 5 on

page 14). To refresh the screen, click Discover.)

3.2 Direct Access Via Web Browser

If the NSA cannot get an IP address from a DHCP

server, then the default IP address of the NSA

reverts to 192.168.1.3. Before directly entering the NSA IP address into your web browser, you must make

sure that your computer and the NSA are in the same subnet. This section shows you how to set your

Windows NT/2000/XP computer to have an IP address in the same subnet as the NSA. Refer to your User’s

Guide for detailed IP address configuration for other operating systems.

1 In Windows XP, click start, Control Panel. In Windows 2000/NT, click Start, Settings, Control Panel.

2 In Windows XP, click Network Connections. In Windows 2000/NT, click Network and Dial-up

Connections.