User's Manual

Chapter 4 ZyXEL Utility
NWD-270N User’s Guide
68
4.7.1 Using PEAP in Vista
Take the following steps to set up WPA, WPA2 or 802.1x security using PEAP in Windows
Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see Section
4.4 on page 53), or configure a profile in the normal way (see Section 4.5 on page 59).
2 In the WPA, WPA2 or 802.1x security screen (see Section 4.4.1.4 on page 56 and
Section 4.4.1.5 on page 57), select PEAP as the EAP Type. Note that the Login Name
and Password fields are greyed-out (not available).
3 Click Next.
4 In the Summary screen that appears, click Save.
5 A message similar to the following appears in the bottom-right of your screen. Click the
message.
Figure 46 Vista Security: Additional Information Required
6 The Enter Credentials screen displays. Enter your User name and Password for the
network to which you want to connect.
Figure 47 Vista Security: Enter Credentials
" If you are not sure what to enter, contact your network administrator.
7 Click OK. The Enter Credentials screen disappears and the NWD-270N tries to
connect to the network. The ZyXEL utility’s Link Info screen displays, showing the
connection status (see Section 4.3 on page 51). If the Link Info screen displays an active
connection, you have successfully completed the procedure.