- ZyXEL USB Powered Travel Router Manual

28
Note: If you change the IP address of the MWR102 in the screen below, you will need to
log into the MWR102 again using the new IP address.
Figure 6 Network Settings > LAN Interface
The table below describes the labels in the screen.
Table 5 Network Settings > LAN Interface
LABEL DESCRIPTION
Router IP
Address
Type the IP address in dotted decimal notation. The default setting is
192.168.100.2. If you change the IP address you will have to log in again with the
new IP address.
Subnet Mask
The subnet mask specifies the network number portion of an IP address. Your
MWR102 will automatically calculate the subnet mask based on the IP address that
you assign. Unless you are implementing subnetting, use the subnet mask
computed by the MWR102.
DHCP
DHCP stands for Dynamic Host Configuration Protocol. It is a protocol for
assigning dynamic IP addresses “automatically”.
DHCP
Client
Range
This field asks you to specify the DHCP Client IP address range (default
100~200). You can also click the “Show Client” button to list those connected
DHCP clients.
Note: In Router mode, the DHCP Server is enabled by default. However, in AP
mode, the DHCP Server disabled by default.
Auto IP
Address
Click the drop down list, you may select “Enabled” to divert the IP Address
automatically or select “Disabled” to ban it. When Enabled e, the system will