- ZyXEL USB Powered Travel Router Manual

31
6.3.1 Push Button Configuration (PBC)
1 Make sure that your MWR102 is turned on and that it is within range of your computer.
2 Make sure that you have installed the wireless client (this example uses the NWD210N)
driver and utility in your notebook.
3 In the wireless client utility, find the WPS settings. Enable WPS and press the WPS
button (Start or WPS button)
4 Log into MWR102’s Web-Based Management Interface and press the Start PBC button
in the Wireless > WPS screen.
Note: Your MWR102 has a WPS button located on its bottom panel, as well as a WPS
button in its configuration utility. Both buttons have exactly the same function; you can
use one or the other.
Note: It doesn’t matter which button is pressed first. You must press the second button
within two minutes of pressing the first one.
The MWR102 sends the proper configuration settings to the wireless client. This may take up to
two minutes. Then the wireless client is able to communicate with the MWR102 securely.
6.3.2 PIN Configuration
When you use the PIN configuration method, you need to use both MWR102’s configuration
interface and the client’s utilities.
1 Launch your wireless client’s configuration utility. Go to the WPS settings and select the
PIN method to get a PIN number.
2 Enter the PIN number to the PIN field in the Wireless > WPS screen on the MWR102.
3 Click Start buttons (or button next to the PIN field) on both the wireless client utility
screen and the MWR102’s WPS Station screen within two minutes.
The MWR102 authenticates the wireless client and sends the proper configuration settings to the
wireless client. This may take up to two minutes. Then the wireless client is able to communicate
with the MWR102 securely.