- ZyXEL USB Powered Travel Router Manual

52
8.4 LAN Interface
The LAN Interface Setup screen allows you to set up your LAN interface, the private IP
of your router’s LAN port, and the subnet mask of your LAN segment. Go to Network >
LAN Interface to access the following screen.
Figure 23 Network > LAN Interface
The following table describes the labels in this screen.
Table 14 Network > LAN Interface
Items
Information
Router IP
Address
The IP of your Router LAN port (default 192.168.100.1).
Subnet Mask
Subnet Mask of you LAN (default 255.255.255.0). All devices
on the network must have the same subnet mask to
communicate on the network.
DHCP
DHCP stands for Dynamic Host Configuration Protocol. It is a
protocol for assigning dynamic IP addresses “automatically”.
DHCP Client
Range
This field asks you to specify the DHCP Client IP address
range (default 100~200). You can also click the “Show Client”
button to list those connected DHCP clients.
Note: In Router mode, the DHCP Server is enabled by
default. However, in AP mode, the DHCP Server disabled by