- ZyXEL USB Powered Travel Router Manual

76
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
4 Disconnect and re-connect the power adaptor to the MWR102.
5 If the problem continues, contact the vendor.
16.3 MWR102 Access and Login
I don’t know the IP address of my MWR102.
1 The default IP address is 192.168.100.1.
2 If you changed the IP address and have forgotten it, you might get the IP address of
the MWR102 by looking up the IP address of the default gateway for your computer.
To do this in most Windows computers, click Start > Run, enter cmd, and then enter
ipconfig. The IP address of the Default Gateway might be the IP address of the
MWR102 (it depends on the network), so enter this IP address in your Internet
browser. Set your device to Router Mode, login (see the Quick Start Guide for
instructions) and go to the Local Network table in the Status screen. Your
MWR102’s IP address is available in the Local Network table.
• If the DHCP setting under Local Network is None, your device has a fixed IP address.
• If the DHCP setting under Local Network is Client, then your device receives an IP address
from a DHCP server on the network.
3 If your MWR102 is a DHCP client, you can find your IP address from the DHCP
server. This information is only available from the DHCP server which allocates IP
addresses on your network. Find this information directly from the DHCP server or
contact your system administrator for more information.
4 Reset your MWR102 to change all settings back to their default. This means your
current settings are lost. See Resetting MWR102 in the Troubleshooting section for
information on resetting your MWR102.
I forgot the password.
1 The default password is 1234.
2 If this does not work, you have to reset the device to its factory defaults. See
Resetting MWR102.
I cannot see or access the Login screen in the Web-Based Configuration
Utility.