- ZyXEL USB Powered Travel Router Manual
77
1 Make sure you are using the correct IP address.
• The default IP address is 192.168.100.1.
• If you changed the IP address (Chapter 5), use the new IP address.
• If you changed the IP address and have forgotten it, see the troubleshooting
suggestions for “I don’t know the IP address of my MWR102”
2 Check the hardware connections, and make sure the LEDs are behaving as
expected. See the Quick Start Guide.
3 Make sure your Internet browser does not block pop-up windows and has
JavaScripts and Java enabled. See Appendix A.
4 Make sure your computer is in the same subnet as the MWR102. (If you know that
there are routers between your computer and the MWR102, skip this step.)
• If there is a DHCP server on your network, make sure your computer is using a
dynamic IP address.
• If there is no DHCP server on your network, make sure your computer’s IP address
is in the same subnet as the MWR102. See Appendix B.
5 Reset the device to its factory defaults, and try to access the MWR102 with the
default IP address.
6 If the problem continues, contact the network administrator or vendor, or try one of
the advanced suggestions.
Advanced Suggestion
I can see the Login screen, but I cannot log in to the MWR102.
1 Make sure you have entered the password correctly. The default password is 1234.
This field is case-sensitive, so make sure [Caps Lock] is not on.
2 This can happen when you fail to log out properly from your last session. Try logging
in again after 5 minutes.
3 Disconnect and re-connect the power adaptor or cord to the MWR102.
4 If this does not work, you have to reset the device to its factory defaults. See
Resetting MWR102.
16.4 Internet Access
I cannot access the Internet.