User guide

Chapter 25 Maintenance
VES-1616F-3x Series User’s Guide
170
25.2 Load Factory Default
Follow the steps below to reset the switch back to the factory defaults.
1 In the Maintenance screen, click the Click Here button next to Load Factory Defaults
to clear all switch configuration information you configured and return to the factory
defaults. The following message appears.
Figure 73 Load Factory Default: Conformation
2 Click OK to display the screen shown next.
Figure 74 Load Factory Default: Start
3 Click OK to begin resetting all switch configurations to the factory defaults and then
wait for the switch to restart. This takes up to two minutes. If you want to access the
switch web configurator again, you may need to change the IP address of your computer
to be in the same subnet as that of the default switch IP address (192.168.1.1).
25.3 Reboot System
Reboot System allows you to restart the switch without physically turning the power off.
Follow the steps below to reboot the switch.
1 In the Maintenance screen, click the Click Here button next to Reboot System to
display the next screen.
Figure 75 Reboot System: Confirmation
Load Factory
Default
Click this button to clear all user-entered configuration information and return the
switch to its factory defaults.
You may need to change the IP address of your computer to be in the same
subnet as that of the default device IP address (192.168.1.1).
Reboot System Click this button to restart the switch without turning the power off. This does not
affect the switch's configuration.
Table 58 Maintenance (continued)
LINK DESCRIPTION