Wireless Gateway Series User's Guide

ZyAIR Wireless Gateway Series User’s Guide
Remote Management 30-3
Table 30-1 Menu 24.11 Remote Management Control
FIELD DESCRIPTION EXAMPLE
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service
Each of these read-only labels denotes a server or service that you
may use to remotely manage the ZyAIR.
Port This field shows the port number for the remote management service.
You may change the port number for a service if needed, but you
must use the same port number to use that service for remote
management.
The DNS Service port number is 53. This cannot be changed.
Access Select the access interface (if any) by pressing the [SPACE BAR].
Choices are: LAN only, WAN only, All or Disable. The default is
LAN only.
LAN only
Secured Client IP The default 0.0.0.0 allows any client to use this service to remotely
manage the ZyAIR. Enter an IP address to restrict access to a client
with a matching IP address.
0.0.0.0
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
30.4.2 Remote Management Limitations
Remote management over LAN or WAN will not work when:
1. A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web
service.
2. You have disabled that service in menu 24.11.
3. The IP address in the Secured Client IP field (menu 24.11) does not match the client IP address.
If it does not match, the ZyAIR will disconnect the session immediately.
4. There is already another remote management session of the same type (Telnet, FTP or Web)
running. You may only have one remote management session of the same type running at one
time.
5. There is a web remote management session running with a Telnet session. A Telnet session will be
disconnected if you begin a web session; it will not begin if there already is a web session.