User`s guide

ZyWALL IDP 10 User’s Guide
103 Chapter 9 Command Line Interface Overview
[on|off] means that you can use either on or off.
6 “Command” refers to a command used in the command line interface (CLI command).
9.1.1 Help Facility
You can issue the help or help all command at any time. The system will display a list of
available commands in response.
9.2 Login
When you log in you will be prompted for the username (“admin”) and password (default is
“1234”). If you changed the password in the web configurator, then use that new password
here. If the password prompt appears before the username prompt, press <ENTER> until you
are prompted for the username. Then enter
admin (this is not changeable) followed by the
password at the password prompt followed by <ENTER>.
9.3 Commands
The following table lists all of the commands that you can use with the ZyWALL.
Table 31 Commands Summary
COMMAND DESCRIPTION
Set Log logmax Set the maximum number of
logs the device generates
every second
System passwd
<value>
Set up the login password.
This is same password used
for console, SSH and web
login.
system
timeout
Set up the management idle
timeout
backup Back up configuration
restore Restore configuration
vlan id Set up vlan id
link <UnTAg|Tag> Enable/disable vlan tag
ip <ip
address>
Set up device ip address
mask Set up device subnet mask
gateway Set up device gateway ip
address