User`s guide

ZyWALL IDP 10 User’s Guide
Chapter 2 Introducing the Web Configurator 28
2.4 Example Configuration Settings
The following table shows an example setup for your ZyWALL. In this setup, the ZyWALL is
behind a NAT router (or firewall) and is given a private IP address. The gateway is also in a
private network. The LAN and WAN ports are both in stealth mode and remote management
is only allowed from the MGMT port.
Policy Check Policy check determines the interface on which traffic will be checked against
the ZyWALL policy rules (both pre-defined and user-defined). By selecting
LAN port, then only traffic coming into the LAN and out through the WAN will
be checked. Similarly, by selecting WAN port, then only traffic coming into
the WAN and out through the LAN will be checked.
REMOTE MGMT WWW Use this screen to configure through which interface(s) and from which IP
address(es) users can use HTTP to manage the ZyWALL.
SNMP Use this screen to configure Simple Network Management Protocol (SNMP)
ZyWALL management.
SSH Use this screen to configure through which interface(s) and from which IP
address(es) users can use Secure Shell to manage the ZyWALL.
IDP Pre-defined All pre-defined IDP policies are already stored in the ZyWALL by default. Use
this screen to see all pre-defined policies or search fro specific ones.
Update Use this screen to set the IP address of the update server and to schedule
automatic downloading.
User-defined Use screen to create your own intrusion protection policies.
Registration Use this screen to register for IDP update server downloads.
LOG & REPORT Access the LOGS, REPORT and ALARM links from here.
LOGS View Log Use this screen to view the logs for the categories that you selected.
REPORT E-Mail Use this screen to configure and schedule e-mailed log reports.
syslog A syslog server is an external logging server used to store and parse logs.
ALARM ALARM Use this screen to configure and set the frequency of (e-mailed) alarms.
MAINTENANCE Password Use this screen to change your password.
Time Setting Use this screen to set your ZyWALL’s time and date.
F/W Upload Use this screen to configure and schedule firmware uploads to your ZyWALL.
Configuration Use this screen to back up, restore ZyWALL configuration settings or reset
them to the factory defaults.
Restart This screen allows you to reboot the ZyWALL without turning the power off.
LOGOUT Click this link to log out of and exit the web configurator. For security reasons,
you should do this after each management session.
Table 2 Screens Summary (continued)
LINK TAB FUNCTION
Table 3 Example Configuration Settings
FIELD EXAMPLE CONFIGURATION
IP Address 10. 10. 1.1 (private IP address)
Subnet Mask 255.255.255. 0