User guide

P2002(A) --- DUT1(PPPoE) =====VPN TUNNEL===== DUT2 --- P2002(B)
(2) Configure as attached file.
Test Steps:
(1) DUT1 WAN is PPPoE.
(2) DUT1 and DUT2 enable SIP ALG.
(3) DUT1 and DUT2 build a VPN tunnel.
(4) P2002(A) dials P2002(B). Connection is success, but P2002(A) can not
hear P2002(B)’s voice; P2002(B) can hear P2002(A).
37. [BUG FIX] SPR ID: 061020683
Symptom: PPPoE and PPTP can't be dropped in SMT24.1.
Condition:
(1) WAN1 is PPPoE or PPTP.
(2) Go to SMT24.1 and click "1" to drop WAN1.
(3) But WAN1 is still alive.
Note: This problem only happens on the device that include 3G WAN.
39. [ENHANCEMENT]
Support SCEP via an RA.
41. [BUG FIX] SPR ID: 070516794, 070517866, 070517874
Symptom: ZyWALL crash when Dialbackup with omni.net Lite Multilink
Condition:
(1) ZyWALL dialbackup port connects with omni.net ISDN TA.
(2)omni.net connects with a ISDN simulator, and PPP server is P2002+.
(3)When WAN is down and the dialbackup is up, ZyWALL crash occurs.
42. [BUG FIX]
Symptom: Can't see the site on the public DMZ from Internet
Topology: PC1---(LAN)-+ +-(WAN1)---Internet-----PC3
| |
+-ZyWALL-+
| |
PC2---(DMZ)-+ +-(WAN2)---Internet
Condition:
The NAT setup of WAN 1 is full feature, and NAT setup of WAN 2 is SUA.
Can't see the site on the public DMZ from Internet
1. Set LAN to 192.168.1.1/24, DMZ to a public subnet.
2. Add a static route to let PC3 can routing to PC2 from WAN1.
3. WAN1 and WAN2 all active and have public IP addresses.
4. Set WAN1 NAT to Full Feature and modify the first defaul NAT rule to:
# Local Start IP Local End IP Global Start IP Global End IP Type
1 192.168.1.1 192.168.1.254 0.0.0.0 N/A M-1
5. Set WAN2 NAT to SUA.
6. PC3 Ping PC2 will failed.