User's Manual

Chapter 4 Wizard Setup
ZyWALL USG 100/200 Series User’s Guide
100
4.8.4 VPN Advanced Wizard
Click the Advanced radio button as shown in Figure 34 on page 95 to display the following
screen.
Figure 39 VPN Advanced Wizard: Step 2
The following table describes the labels in this screen.
Table 18 VPN Advanced Wizard: Step 2
LABEL DESCRIPTION
Remote
Gateway
Name Type the name used to identify this VPN connection (and VPN gateway). You may
use 1-31 alphanumeric characters, underscores(
_), or dashes (-), but the first
character cannot be a number. This value is case-sensitive.
Secure
Gateway
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by its IP address or a
domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN
IP address.
My Address
(interface)
Select an interface from the drop-down list box to use on your ZyWALL.
Authentication
Method
Pre-Shared
Key
Type your pre-shared key in this field. A pre-shared key identifies a communicating
party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to
share it with another party before you can communicate with them over a secure
connection.
Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
9", "A-F") characters. Precede hexadecimal characters with “0x”.
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not
used on both ends.