User's Manual

Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
789
HTTPS port has been
changed to default
port.
An administrator changed the port number for HTTPS back to the
default (443).
HTTP port has changed
to port %s.
An administrator changed the port number for HTTP.
%s is port number assigned by user
HTTP port has changed
to default port.
An administrator changed the port number for HTTP back to the
default (80).
SSH port has been
changed to port %s.
An administrator changed the port number for SSH.
%s is port number assigned by user
SSH port has been
changed to default
port.
An administrator changed the port number for SSH back to the default
(22).
SSH certificate:%s
does not exist. SSH
service will not work.
An administrator assigned a nonexistent certificate to SSH.
%s is certificate name assigned by user
SSH certificate:%s
format is wrong. SSH
service will not work.
After an administrator assigns a certificate for SSH, the device needs
to convert it to a key used for SSH.
%s is certificate name assigned by user
TELNET port has been
changed to port %s.
An administrator changed the port number for TELNET.
%s is port number assigned by user
TELNET port has been
changed to default
port.
An administrator changed the port number for TELNET back to the
default (23).
FTP certificate:%s
does not exist.
An administrator assigned a nonexistent certificate to FTP.
%s is certificate name assigned by user
FTP port has been
changed to port %s.
An administrator changed the port number for FTP.
%s is port number assigned by user
FTP port has been
changed to default
port.
An administrator changed the port number for FTP back to the default
(21).
SNMP port has been
changed to port %s.
An administrator changed the port number for SNMP.
%s is port number assigned by user
SNMP port has been
changed to default
port.
An administrator changed the port number for SNMP back to the
default (161).
Console baud has been
changed to %s.
An administrator changed the console port baud rate.
%s is baud rate assigned by user
Console baud has been
reset to %d.
An administrator changed the console port baud rate back to the
default (115200).
%d is default baud rate
DHCP Server on
Interface %s will not
work due to Device HA
status is Stand-By
If interface is stand-by mode for device HA, DHCP server can't be run.
Otherwise it has conflict with the interface in master mode.
%s is interface name
Table 294 Built-in Services Logs (continued)
LOG MESSAGE DESCRIPTION