User's Manual

Prestige 100L IDSL Router

2-4 Hardware Installation and Initial Setup

2.4 Power Up Your Prestige

When you power on your Prestige, it performs several internal tests and also does an IDSL line

initialization. After this initialization, your Prestige asks you to press the [Enter] key to continue as shown

on the initial screen.

Initial Screen

Figure 2-3 Initial Screen

Entering Password

The login screen appears after you press the [Enter] key, prompting you to enter the password as shown on

the next screen.

For your first login, enter the default password 1234. As you type the password, the screen displays an (X)

for each character you type.

Please note that if there is no activity longer than 5 minutes after you log in, your Prestige automatically

logs you out and displays a blank screen. If you see a blank screen, press the [Enter] key to bring up the

Figure 2-4 Password Screen

2.5 Navigating the SMT (System Management Terminal)

Interface

The SMT is the interface that you use to configure your Prestige.

Several operations that you should be familiar with before you attempt to modify the configuration are

listed in the following table.

Enter Password: XXXX

ethernet address: 00:a0:c5:01:23:45

Resetting IDSL Firmware.(2) IDSL Firmware Rev : V 09E

...............................

Press ENTER to continue...