Manualshelf

User's Manual

ManualsBrandsZyXEL ManualsNetworking100L
919293949596979899100
Prestige 100L IDSL Router
Transferring Files11-6
NOTE: If you upload the firmware to the Prestige, it reboots automatically when the
file transfer is completed (the SYS LED flashes).
Note that the telnet connection must be active and the SMT in CI mode before and during the TFTP
transfer. For details on TFTP commands (see following example), please consult the documentation of your
TFTP client program. For UNIX, use get to transfer from the Prestige to the workstation, put the other
way around, and binary to set binary transfer mode.
11.5.1 Using the FTP Command From the DOS Prompt
Step 1. Launch the FTP client on your workstation.
Step 2. Type open and the IP address of your Prestige.
Step 3. You may press the [Enter] key when prompted for a username.
Step 4. Type root and your SMT password as requested. The default is 1234.
Step 5. Type bin to set transfer mode to binary.
Step 6. Use put to transfer files from the workstation to the Prestige, e.g., put p100l.bin ras
transfers the firmware on your computer (p100l.bin) to the Prestige and renames it “ras”.
Similarly put p100l.rom rom transfers the configuration file on your computer (p100l.rom) to
the Prestige and renames it “rom”.
Step 7. Type quit to exit the ftp prompt.
Figure 11-6 FTP Session Example
Menu 24.7.2 - System Maintenance - Upload Router Configuration File
To upload router configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur3" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The router's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed:(Y/N)