User`s guide

ManualsBrandsZyXEL ManualsNetworking793H v2

101

102

103

104

105

106

107

108

109

110

P-793H v2 Support Notes

2. Type the CI command 'sys stdio 0' to disable console idle timeout in

Command Line Interface (CLI)

Example:

[cppwu@faelinux cppwu]$ telnet 192.168.1.1

Trying 192.168.1.1...

Connected to 192.168.1.1.

Escape character is '^]'.

Password: ****

ras> sys stdio 0

(Open a new window)

[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 get rom-0 [local-rom] <- change to binary mode

<- download configurations

[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 put [local-rom] rom-0 <- upload configurations

[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 get ras [local-ras ] <- download firmware

[cppwu@faelinux cppwu]$ tftp -I 192.168.1.1 put [local-ras] ras <- upload firmware

3. Using FTP to Upload the Firmware and Configuration Files

In addition to upload the firmware and configuration file via the console port

and TFTP client, you can also upload the firmware and configuration files to

the P-793H v2 using FTP.

To use this feature, your workstation must have a FTP client software. See the

example shown below.



Using FTP client software

Note: The remote file name for the firmware is 'ras' and the configuration file is

'rom-0'.

Step 1

Use FTP client from your workstation to connect to the P-793H v2 by

entering the IP address of the P-793H v2.

Step2

Press 'Enter' key to ignore the username, because the P-793H v2 does

not check the username.

Step 3

Enter the CLI password as the FTP login password, the default is

'admin'.

Step 4

Enter command 'bin' to set the transfer type to binary.

106