User's Manual

ZyXEL AG-320 User’s Guide
24 Chapter 1 Getting Started
The following table describes the operation of the LINK and ACT LEDs on the rear of the
device.
1.2 Application Overview
This section describes some network applications for the AG-320.
1.2.1 Station Mode
The AG-320 is in wireless station mode by default. When the AG-320 works as a wireless
station (wireless client), you can either set the network type to Infrastructure and connect to
an AP or use Ad-Hoc mode and connect to a peer computer (another wireless device in Ad-
Hoc mode).
1.2.1.1 Infrastructure
To connect to a network via an access point (AP), set the AG-320 network type to
Infrastructure using the Profile screen. Through the AP, you can access the Internet or the
wired network behind the AP.
Table 2 AG-320 LEDs
LED STATE DESCRIPTION
LINK On The AG-320 is receiving power.
Off The AG-320 is not receiving power.
ACT Blinking The AG-320 is sending or receiving data.
Off The AG-320 is not sending or receiving data.