User's Manual

Chapter 28 Bandwidth Management
ZyWALL USG 20/20W User’s Guide
461
28.2 TheBandwidth Management Screen
The Bandwidth management screen controls the default policy for TCP and UDP
traffic. You can use source zone, destination zone, destination port, schedule,
user, source, and destination information as criteria to create a sequence of
specific conditions, similar to the sequence of rules used by firewalls, to specify
what the ZyWALL should do more precisely.This screen also allows you to add,
edit, and remove conditions to this default policy.
Click Configuration > Bandwidth Management to open the following screen.
Figure 286 Configuration > Bandwidth Management
The following table describes the labels in this screen. See Section 28.2.1 on page
463 for more information as well.
Table 131 Configuration > Bandwidth Management
LABEL DESCRIPTION
Enable BWM Select this check box to activate management bandwidth.
Add Click this to create a new entry. Select an entry and click Add to create a
new entry after the selected entry.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Move To change an entry’s position in the numbered list, select it and click
Move to display a field to type a number for where you want to put that
entry and press [ENTER] to move the entry to the number that you
typed.
Status The activate (light bulb) icon is lit when the entry is active and dimmed
when the entry is inactive.