User's Manual

Chapter 28 Bandwidth Management
ZyWALL USG 20/20W User’s Guide
463
28.2.1 The Bandwidth Management Add/Edit Screen
The Configuration > Bandwidth Management Add/Edit screen allows you to
create a new condition or edit an existing one. To access this screen, go to the
Configuration > Bandwidth Management screen (see Section 28.2 on page
461), and click either the Add icon or an Edit icon.
Figure 287 Configuration > Bandwidth Management > Edit
BWM These fields show the amount of bandwidth the traffic can use.
In - This is how much inbound bandwidth, in kilobits per second, this
policy allows the matching traffic to use. Inbound refers to the traffic the
ZyWALL sends to a connection’s initiator. If no displays here, this policy
does not apply bandwidth management for the inbound traffic.
Out - This is how much outgoing bandwidth, in kilobits per second, this
policy allows the matching traffic to use. Outbound refers to the traffic
the ZyWALL sends out from a connection’s initiator. If no displays here,
this policy does not apply bandwidth management for the outbound
traffic.
Pri - This is the priority for the traffic that matches this policy. The
smaller the number, the higher the priority. Traffic with a higher priority
is given bandwidth before traffic with a lower priority. The ZyWALL
ignores this number if the incoming and outgoing limits are both set to
0. In this case the traffic is automatically treated as being set to the
lowest priority (7) regardless of this field’s configuration.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
Table 131 Configuration > Bandwidth Management
LABEL DESCRIPTION