User's Manual

Appendix A Log Descriptions
ZyWALL USG 20/20W User’s Guide
765
IKE Packet Retransmit When retransmitting the IKE packets.
Phase 1 IKE SA process
done
When Phase 1 negotiation is complete.
Recv Main Mode request
from [%s]
%s is the remote name; When receiving a request to enter
Main mode.
Recv Aggressive Mode
request from [%s]
%s is the remote name; When receiving a request to enter
Aggressive mode.
Recv:[SA][KE][ID][CER
T][CR][HASH][SIG][NON
CE][DEL][VID][ATTR][N
OTFY:%s]
This is a combined message for incoming IKE packets
Send Main Mode request
to [%s]
%s is the remote name. The device sent a request to enter
Main Mode.
Send Aggressive Mode
request to [%s]
%s is the remote name. The device sent a request to enter
Aggressive Mode.
Send:[SA][KE][ID][CER
T][CR][HASH][SIG][NON
CE][DEL][VID][ATTR][N
OTFY:%s]
This is a combined message for outgoing IKE packets.
Start Phase 2: Quick
Mode
Indicates the beginning of phase 2 using quick mode.
The cookie pair is :
0x%08x%08x /
0x%08x%08x
Indicates the initiator/responder cookie pair.
The IPSec tunnel "%s"
is already established
%s is the tunnel name. When dialing a tunnel, the tunnel is
already dialed.
Tunnel [%s] built
successfully
%s is the tunnel name. The phase-2 tunnel negotiation is
complete.
Tunnel [%s] Phase 1
pre-shared key
mismatch
%s is the tunnel name. When negotiating phase-1, the pre-
shared key did not match.
Tunnel [%s] Recving
IKE request
%s is the tunnel name. The device received an IKE request.
Tunnel [%s] Sending
IKE request
%s is the tunnel name. The device sent an IKE request.
Tunnel [%s] IKE
Negotiation is in
process
%s is the tunnel name. When IKE request is already sent but
still attempting to dial a tunnel.
VPN gateway %s was
disabled
%s is the gateway name. An administrator disabled the VPN
gateway.
VPN gateway %s was
enabled
%s is the gateway name. An administrator enabled the VPN
gateway.
XAUTH fail! My name:
%s
%s is the my xauth name. This indicates that my name is
invalid.
XAUTH fail! Remote
user: %s
%s is the remote xauth name. This indicates that a remote
user’s name is invalid.
Table 247 IKE Logs (continued)
LOG MESSAGE DESCRIPTION