User's Manual

Chapter 6 Configuration Basics
ZyWALL USG 20/20W User’s Guide
96
6.5.2 Licensing Registration
Use these screens to register your ZyWALL and subscribe to services like more
SSL VPN tunnels, and content filtering. You must have Internet access to
myZyXEL.com.
6.5.3 Interface
See Section 6.2 on page 88 for background information.
Note: When you create an interface, there is no security applied on it until you assign
it to a zone.
Most of the features that use interfaces support Ethernet, PPPoE/PPTP, cellular,
VLAN, and bridge interfaces.
Example: The dmz interface is in the DMZ zone and uses a private IP address. To
configure dmz’s settings, click Network > Interface > Ethernet and then the
dmz’s Edit icon.
6.5.4 Trunks
Use trunks to set up load balancing using two or more interfaces.
Example: See Chapter 7 on page 107.
6.5.5 Policy Routes
Use policy routes to override the ZyWALL’s default routing behavior in order to
send packets through the appropriate interface or VPN tunnel. You can also use
policy routes for bandwidth management (out of the ZyWALL), port triggering,
MENU ITEM(S)
Configuration > Licensing > Registration
PREREQUISITES
Internet access to myZyXEL.com
MENU ITEM(S)
Configuration > Network > Interface (except Network >
Interface > Trunk)
PREREQUISITES
Port groups (configured in the Interface > Port Grouping screen)
WHERE USED
Zones, trunks, IPSec VPN, DDNS, policy routes, static routes, HTTP
redirect, NAT
MENU ITEM(S)
Configuration > Network > Interface > Trunk
PREREQUISITES
Interfaces
WHERE USED
Policy routes