User's Manual

Chapter 24 User/Group
NXC CLI Reference Guide
172
24.2.3.1 User Setting Command Examples
The following commands show the current settings for the number of simultaneous logins.
users default-setting [no] user-type <admin
|ext-user|guest|limited-admin|ext-group-user>
Sets the default user type for each new user. The
no command sets the default user type to user.
show users retry-settings Displays the current retry limit settings for users.
[no] users retry-limit Enables the retry limit for users. The
no command
disables the retry limit.
[no] users retry-count <1..99> Sets the number of failed login attempts a user can
have before the account or IP address is locked out
for lockout-period minutes. The
no command sets
the retry-count to five.
[no] users lockout-period <1..65535> Sets the amount of time, in minutes, a user or IP
address is locked out after retry-count number of
failed login attempts. The
no command sets the
lockout period to thirty minutes.
show users simultaneous-logon-settings Displays the current settings for simultaneous
logins by users.
[no] users simultaneous-logon {administration
| access} enforce
Enables the limit on the number of simultaneous
logins by users of the specified account-type. The
no command disables the limit, or allows an
unlimited number of simultaneous logins.
[no] users simultaneous-logon {administration
| access} limit <1..1024>
Sets the limit for the number of simultaneous logins
by users of the specified account-type. The no
command sets the limit to one.
show users update-lease-settings Displays whether or not access users can
automatically renew their lease time.
[no] users update-lease automation Lets users automatically renew their lease time.
The
no command prevents them from
automatically renewing it.
show users idle-detection-settings Displays whether or not users are automatically
logged out, and, if so, how many minutes of idle
time must pass before they are logged out.
[no] users idle-detection Enables logging users out after a specified number
of minutes of idle time. The no command disables
logging them out.
[no] users idle-detection timeout <1..60> Sets the number of minutes of idle time before
users are automatically logged out. The no
command sets the idle-detection timeout to three
minutes.
Table 99 username/groupname Commands Summary: Settings (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# show users simultaneous-logon-settings
enable simultaneous logon limitation for administration account: yes
maximum simultaneous logon per administration account : 1
enable simultaneous logon limitation for access account : yes
maximum simultaneous logon per access account : 3