User's Manual

Chapter 1 Introducing the ZyWALL
ZyWALL USG 2000 User’s Guide
37
1 Insert the transceiver into the slot with the exposed section of PCB board facing
down.
Figure 4 Transceiver Installation Example
2 Press the transceiver firmly until it clicks into place.
Figure 5 Installed Transceiver
3 Push the end of the fiber-optic cable firmly into the transceiver until it locks into
place. When the other end of the fiber-optic cable is connected, check the LEDs to
verify the link status.
Figure 6 Installing the Fiber-optic Cable
Fiber-optic Cable and Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module).