User's Manual

Chapter 6 Configuration Basics
ZyWALL USG 2000 User’s Guide
98
6.2.2 Default Interface and Zone Configuration
This section introduces the ZyWALL’s default zone member physical interfaces and
the default configuration of those interfaces. The following figure uses letters to
denote public IP addresses or part of a private IP address.
Figure 63 Default Network Topology
Table 13 Default Port, Interface, and Zone Configuration
• The LAN zone contains the ge1 interface. The LAN zone is a protected zone. The
ge1 interface uses 192.168.1.1.
• The WAN zone contains the ge2 and ge3 interfaces (physical ports 2 and 3).
They use public IP addresses to connect to the Internet.
PORT INTERFACE ZONE
IP ADDRESS AND DHCP
SETTINGS
SUGGESTED USE WITH
DEFAULT SETTINGS
P1 ge1 LAN 192.168.1.1, DHCP server
enabled
Protected LAN
P2, P3 ge2, ge3 WAN DHCP clients Connections to the Internet
P4~P6 ge4, ge5,
ge6
DMZ 192.168.2.1,
192.168.3.1,
192.168.4.1, DHCP server
disabled
Public servers (such as web,
e-mail and FTP)
P7, P8 ge7, ge8 None None, DHCP server
disabled
Configure and use these
interfaces according to your
requirements. Add them to
existing zones or create new
zones for them.
AUX aux None None Auxiliary modem
CONSOLE N/A None None Local management